Cabinet design software – mitered corners and contours
A user emailed me about a problem using our cabinet design software in his project. It’s a great example of clear communication – to the point with a screen shot to show the issue. I sent back a solution and will now make a video to discuss it.
Two boards meet in the corner and both boards have a rounded over contour on top and a miter on the ends. He ran into a limitation in SketchList 3D where cutting a hole can’t overlap other holes. This applies to joinery and contours as well.
You see the gap in the top of the corner. I ‘cut’ a corner piece with a round over contour going both ways and stuck it in the gap.
Watch the video. It contains some cool tips and tricks. Near the end of the videos I make good use of blue dots to connect things.
Thank you for your time. If you have any questions or comments level them below.