Fluted Columns in Woodworking Design Software

Cut Flutes in Board with Woodworking Design Software

flute on a board woodworking design software

A user of SketchList 3D woodworking design software emailed in asking if it is possible to cut flutes in a board surface.  Yes it is.  The process is pretty simple and fast.  First select the board at the board detail level.  Then select the surface you want to flute.  The image above shows the surface in blue.  Click on non-round holes.

flute in wood working design software

 

In this example the flute runs from bottom to top.  That is a = 0 and height = board height.  You might start the bottom at 6 and wrap the bottom of the column with some sort of footer.  B is the distance from the left.  Make it as wide as you like.  For fun – make it almost as wide as the board:  14 inch board try a 8 inch wide flute.

Click contour edge and pick round over.  Accept defaults.  [It may be you need to edit this hole to set the contour.]  Then you have flute number one.

Click the Edit / Clone Holes button while at the board detail level.

flute clone and space woodworking design software

Enter the number of flutes you want to cut, check fixed spacing, and set the distance between the flutes.  Pick “from the left edge”.

This is another post [2015] describing an over the top use of this technique.  You can see it at CLICK HERE.