Round Hole

 

For a hole you would enter the diameter  and depth of the hole.  A hole can be less than the thickness of the board.

:Locate the hole by its distance from the bottom of the board (A value) and its distance from the left of the board (B distance).  This distance is to the center of the hole.

CHECK EDGES

You may be designing with the Imperial (feet and inches) system but want a hole in metric (European hinge).  Check the correct box to do this.

This image provides visual feedback on the size and location of the hole(s) on this board.

Notes will appear on reports.

You have the ability to place a contour on the inside of a hole.  The hole must be created and saved before you can contour that hole.